Installing the vibration damper

• Coat sealing surface on the vibration damper (1) with clean engine oil.
• Position vibration damper (1).
• Replace the bolts (arrows).

  Parts:  Bolts

• Tighten the bolts (arrows) on the vibration damper (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Vibration damper with belt pulley to crankshaft
  M10 Replace screws.	1. Jointing torque  2. Angle of rotation	40 Nm 120°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip the cover (1) in at the vibration damper.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (2).
• Slide the counter support with the screw (2) down against the direction of arrow, until the teeth (3) are no longer engaged in the gearing of the flywheel (4).
• Unscrew the screw (1) and remove the special tool 0496 595 (11 6130). 

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Refer to INSTALLING STARTER MOTOR .
• Refer to INSTALLING THE REAR STIFFENING PLATE .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT STIFFENING PLATE .
• Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALLING THE DRIVE BELT FOR THE COOLANT PUMP .
• Refer to INSTALL THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to INSTALL CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALL RESONATOR .
• Refer to INSTALL ACOUSTIC COVER .