Overview - Gear Set, Vehicles With Self-Locking Center Differential
Courtesy of AUDI OF AMERICA, LLC- Oil Pipe
- Bolt
- M6 X 30
- Replace after removing
- 3 Nm +90°
- Gear Positioner with:
- Transmission Input Speed Sensor 1 -G632-
- Transmission Input Speed Sensor 2 -G612-
- Gear Position Distance Sensor 1 -G487-
- Gear Position Distance Sensor 2 -G488-
- Gear Position Distance Sensor 3 -G489-
- Gear Position Distance Sensor 4 -G490-
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Replace after removing
- Oil Pan
- Replace after removing
- Bolts
- M6 X 30
- Replace after removing
- 3 Nm +90°
- Needle Bearing
- Bearing "31"
- Seal
- Replace after removing
- Hydraulic Pressure Reservoir
- Draining. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Disposing. Refer to HYDRAULIC PRESSURE RESERVOIR, DISPOSING .
- Tightening specification and sequence. Refer to Fig 2.
- Bolts
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Bearing Bracket with Roller Bearing
- Bearing "N"
- Tightening specification and sequence. Refer to Fig 2.
- Gear Set
- Removing and Installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Needle Bearing
- Bearing "33"
- Bolts
- M6 X 50
- Gearshift rail gear actuator module
- 6 Nm +30°
Gear Actuator, Pressure Reservoir, Gear Carrier - Tightening Specification and Sequence
Courtesy of AUDI OF AMERICA, LLC-- Tighten the bolts in four steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 9- | 3 Nm |
| 2 | -1 to 6- | 90° (M6 X 30) |
| 3 | -7 to 9- | 5 Nm |
| 4 | -7 to 9- | 120° (M6 X 40) |