Check the clutch installation height
- Before installing the clutch the dimension -x- must be determined.
- To do so use the Ruler (2 pc.): T40100 and Digital Depth Gauge: VAS 6087 to determine the height of the clutch cover to the hub offset as shown.
The dimension -x- must be within the tolerance of 98.91 to 99.61 mm (3.89 to 3.92 in.).
- The hub -2- is engaged in the inner disk support and can be loosed through mishandling of the clutch -1-.
- If the dimension is outside of the tolerance, engage the hub -2- again by carefully pushing in the direction -arrow A- and -arrow B- in the coupling -1-.
-- Insert the dual clutch as shown in the transmission housing.
-- Tighten the bolts -1 to 12- for the clutch cover diagonally in steps.
-- Install the flywheel. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- After installing the transmission fill the ATF and transmission fluid. Refer to ATF, DRAINING AND FILLING and the appropriate service information .
- If the dual clutch is replaced, the dual clutch must be adapted using the.
Dual clutch, adapting
-- Connect the Vehicle Diagnostic Tester with the vehicle.
- Network plan or control module list
- 02 - Transmission Electronics, Guided Functions
- 02 - Basic Setting
- Adapt clutch slip points
-- Start the selected program and follow the instructions in the display of the Vehicle Diagnostic Tester.
Tightening Specifications