Oil Pressure Regulation Valve -N428-, Removing And Installing
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit :SMN372500
Procedure
-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Disconnect the connector -1-.
-- Position the :SMN372500 underneath.
-- Remove the bolt -2- and the Oil Pressure Regulation Valve -N428-.
- Replace the O-ring if it is damaged or if there are leaks.
-- To prevent oil loss, immediately install the new valve.
-- Check the oil level. Refer to ENGINE OIL .
Tightening Specifications
- Refer to OVERVIEW - OIL PRESSURE SWITCH/OIL PRESSURE REGULATION
- Refer to OVERVIEW - NOISE INSULATION .