Coolant Pump, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
-- Position the toothed belt and bring the coolant pump -1- into installation position.
-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.
-- Tighten the coolant pump bolts. Refer to Figure.
-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.
- Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
- Used coolant cannot be used again.
-- Connect the coolant hose to the connector coupling. Refer to Figure.
-- Fill with coolant. Refer to COOLANT, FILLING .
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .