Engine Temperature Control Actuator -N493-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
- Replace the seals and O-ring after removal.
- Used coolant cannot be used again.
-- Coat the new O-rings -4- with coolant. Refer to the Parts Information.
-- Make sure both alignment pins are installed in the cylinder block (install if necessary).
-- Install the connection piece -2- into the engine oil cooler -1-.
-- Push the Engine Temperature Control Actuator -N493- -3- onto the connecting piece and centering pins in the cylinder block.
-- Tighten the bolts for the Engine Temperature Control Actuator -N493-. Refer to Figure.
-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
-- Install the Throttle Valve Control Module -GX3-. Refer to Throttle Valve Control Module -GX3-, REMOVING AND INSTALLING .
-- Connect the coolant hose to the connector coupling. Refer to Figure.
-- Fill with coolant. Refer to COOLANT, FILLING .