Ribbed Belt, Removing And Installing, Vehicle With Starter Generator: Installing

Install in the reverse order of removal while noting the following:

-- Install the ribbed belt. Refer to Figure.

• If the ribbed belt tensioner is not locked the assembly condition must be created next. Refer to 2. If there is no ribbed belt installed (torn, for example): .

-- Turn the tensioning system slightly in the direction of -arrow- and remove the Locking Pin: T10060A  .

-- Release the tension on the tensioner.

-- Check whether the ribbed belt is routed correctly.

-- Start the engine and check whether the ribbed belt runs correctly.