Overview - Gear Set, Vehicles Without Self-Locking Center Differential
Courtesy of AUDI OF AMERICA, LLC- Oil Pipe
- Bolt
- M6 X 30
- Replace after removing
- 3 Nm +90°
- Gear Actuator
- Transmission Input Speed Sensor 1 -G632-
- Transmission Input Speed Sensor 2 -G612-
- Gear Position Distance Sensor 1 -G487-
- Gear Position Distance Sensor 2 -G488-
- Gear Position Distance Sensor 3 -G489-
- Gear Position Distance Sensor 4 -G490-
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Seal
- Replace after removing
- Oil Pan
- Replace after removing
- Bolt
- M6 X 30
- Replace after removing
- 3 Nm +90°
- Seal
- Replace after removing
- Hydraulic Pressure Reservoir
- Draining. Refer to ATF PUMP, DEACTIVATING AND DRAINING THE HYDRAULIC PUMP RESERVOIR .
- Removing and Installing. Refer to GEAR ACTUATOR MODULE AND HYDRAULIC PRESSURE RESERVOIR, REMOVING AND INSTALLING .
- Disposing. Refer to HYDRAULIC PRESSURE RESERVOIR, DISPOSING .
- Bolts
- M6 X 30
- Replace after removing
- 3 Nm +90°
- Gear Set
- Removing and Installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Disassembling and Assembling. Refer to GEAR SET, DISASSEMBLING AND ASSEMBLING .
- Bolts
- M6 X 50
- Gearshift rail gear actuator module
- 6 Nm +30°
Gear actuator and pressure reservoir - tightening specification and sequence
Courtesy of AUDI OF AMERICA, LLC- Replace the bolts after removing them.
-- Tighten the bolts in two steps in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1 | -1 to 8- | 3 Nm |
| 2 | -1 to 8- | 90° |