DEFROSTER DOOR MOTOR -V107-, REMOVING AND INSTALLING, "High" A/C SYSTEM: Installing

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal and note the following:

-- Check the gear -A- for correct installation.

-- Check the defroster door actuation for function and ease of movement by turning the gear -A-.

Courtesy of AUDI OF AMERICA, LLC

• The actuator mount does not have a stop. It turns constantly if the actuator is activated. Therefore, it should not be activated when the actuator is removed.
• Check the connection between the actuator mount and the shaft; there must not be any play.

-- Check the shaft -A- and the mount -B- for the actuator -C-. They must be properly aligned so that they can be joined.

-- Attach the actuator mount -B- to the door shaft -A-.

-- Check the connection between the mount -D- for the actuator -C- and the shaft -E- ; there must not be any play.

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -A-.

-- Tighten the bolts -B-.

-- Route the wiring harness to the connector -A- so that it cannot come in contact with any moving parts.

-- Perform a basic setting for the A/C system. Refer to GENERAL INFORMATION AND PROCEDURES - ACTUATORS, REMOVING AND INSTALLING .

Tightening Specification

• Refer to OVERVIEW - FRONT ADJUSTMENT MOTORS, ON A "High" A/C SYSTEM