Adjust track and camber
Adjustment of camber/track on wishbone
Preliminary work
- PROCEDURE for track and camber adjustment in design position.
- PROCEDURE for adjusting track/camber for ride-height-dependent measurement (unloaded).
Diagram dependency of track/camber adjustment
(For printing out and entering values)
NOTE:
TECHNICAL INFORMATION
Through the turning of the eccentric screws (setting of camber and track), the vehicle ride height can change. For the exact setting of the camber and track, the automatic ride height measurement should be activated in the wheel alignment equipment when available.
Through the turning of the eccentric screws (setting of camber and track), the vehicle ride height can change. For the exact setting of the camber and track, the automatic ride height measurement should be activated in the wheel alignment equipment when available.
NOTE:
TECHNICAL INFORMATION
Turning the adjustment screw on the camber control arm or on the wishbone always results in a change in the camber and track values! Separate camber or toe adjustment is no longer possible!
Turning the adjustment screw on the camber control arm or on the wishbone always results in a change in the camber and track values! Separate camber or toe adjustment is no longer possible!
NOTE:
TECHNICAL INFORMATION
Check the alignment of the active cruise control (ACC) after an adjustment on the rear axle that changes the driving axis.
Check the alignment of the active cruise control (ACC) after an adjustment on the rear axle that changes the driving axis.
- Adjusting on wishbone:
- Turn eccentric screw (2) until intermediate adjustment value is obtained.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATIONUpper wishbone to rear axle carrier M14
Replace bolt, nut and eccentric washer.
Tighten in NORMAL POSITIONTightening torque 175 Nm - Adjusting on camber control arm:
- Turn eccentric screw (2) to adjust to the setpoint value.
- Tighten nut (1).
TIGHTENING TORQUES SPECIFICATION
| Camber control arm to rear axle support | ||
| M14 Replace bolt, nut and eccentric washer. Tighten in NORMAL POSITION |
Tightening torque | 175 Nm |
Follow-up work