Installing the central magnet
- Replace O-rings.
Parts : O-rings
- Screw in the central magnet valve (1) in the direction of the arrow using special tool 2 360 895 .
Follow-up work
- Refer to INSTALLING THE LEFT HIGH PRESSURE PUMP .
- Refer to INSTALLING FUEL DELIVERY LINE .
- Refer to PREPARING THE INJECTOR FOR INSTALLATION .
- Refer to INSTALLING INJECTORS .
- Refer to INSTALLING THE SOUND INSULATION ON THE RIGHT-HAND CYLINDER HEAD COVER .
- Refer to MOUNTING THE WIRING HARNESS ON THE CYLINDER HEAD COVER ON THE LEFT .
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING LEFT CLEAN AIR PIPE .
- Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
- Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS CONTROL UNIT ON THE RIGHT .
- Refer to INSTALLING THE DME CONTROL UNIT FOR CYLINDERS 1 TO 4 .
- Refer to HEAT PROTECTION OF THE LEFT-HAND CATALYTIC CONVERTER PIPE .
- Refer to HEAT PROTECTION OF THE TOP LEFT-HAND CATALYTIC CONVERTER PIPE .
- Refer to HEAT PROTECTION OF THE RIGHT-HAND CATALYTIC CONVERTER PIPE .
- Refer to HEAT PROTECTION OF THE TOP RIGHT-HAND CATALYTIC CONVERTER PIPE .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to IF INSTALLED: INSTALL THE TORSION STRUT ON THE RIGHT, AND ON THE LEFT WHERE REQUIRED .
- Refer to INSTALLING HEAT SHIELD, TOP .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR AND THE MONITORING OXYGEN SENSOR FOR CYLINDERS 1 TO 4 .
- Refer to INSTALLING THE LAMBDA OXYGEN SENSOR AND THE MONITORING OXYGEN SENSOR FOR CYLINDERS 5 TO 8 .
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING RIGHT CLEAN AIR PIPE .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to INSTALL ACOUSTIC COVER .
- Refer to CHECKING THE COOLANT LEVEL IN THE LOW-TEMPERATURE COOLANT CIRCUIT AND TOP UP, IF NEEDED .