Installing the left engine support bracket
- Install the engine support bracket (2).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Engine support bracket on the engine M10 Tightening torque 38 Nm
Follow-up work
- Refer to INSTALL FRONT AXLE COMPLETELY (540i 2017-2022) , or RAISE FRONT AXLE SUPPORT (540i xDrive 2017-2022) .
- Refer to TIGHTEN THE SCREWS ON THE LEFT AND RIGHT FRONT AXLE SUPPORT (540i 2017-2022) , or TIGHTEN THE BOLTS ON THE FRONT AXLE SUPPORT (540i xDrive 2017-2022) .
- Refer to SECURE THE SPRING STRUT TO THE BOTTOM WISHBONE .
- Refer to SECURE THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to REMOVING THE MOBILE LIFTING TABLE .
- Refer to ATTACHING COOLANT HOSES TO FRONT SUBFRAME .
- Refer to ATTACHING THE UNIVERSAL JOINT TO STEERING GEAR (540i 2017-2022) , or ATTACHING THE UNIVERSAL JOINT TO STEERING GEAR (540i xDrive 2017-2022) .
- Refer to IF INSTALLED: CONNECT THE CONNECTOR OF THE ACTIVE STABILIZER
- Refer to INSTALL THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
- Refer to SECURING CABLES ON VERTICAL ACCELERATION SENSOR ON RIGHT AND LEFT .
- Refer to ATTACHING THE CABLE OF THE WHEEL RPM SENSOR ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE BRAKE CALIPER AT THE FRONT LEFT AND RIGHT .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR (540i 2017-2022) , or SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR (540i xDrive 2017-2022) .
- Refer to IF INSTALLED: INSTALL THE SILENCER OF THE STATIONARY HEATING (ADDITIONAL WORK FRU NO.: 31 11 905) .
- Refer to INSTALL THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT
- Refer to INSTALL LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to SECURE THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
- Refer to INSTALL THE REINFORCEMENT STRUT ON THE ENGINE MOUNT ON THE LEFT AND RIGHT
- Refer to INSTALL THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALL THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALL THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE MOUNT OF THE HOOD SEAL .
- Refer to INSTALL THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
- Refer to TAKE HOOD OUT OF THE SERVICE POSITION .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALL RESONATOR .
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .