Installing the acoustic cover for the oil pan

Follow-up work 

• Refer to RAISE FRONT AXLE SUPPORT .
• Refer to TIGHTEN THE SCREWS ON THE LEFT AND RIGHT FRONT AXLE SUPPORT .
• Refer to SECURE THE SPRING STRUT ON THE WISHBONE ON THE BOTTOM LEFT AND RIGHT .
• Refer to SECURE THE WISHBONE ON THE TOP LEFT AND RIGHT ON THE SWIVEL BEARING .
• Refer to REMOVING THE MOBILE LIFTING TABLE .
• Refer to ATTACHING COOLANT HOSES TO FRONT SUBFRAME .
• Refer to ATTACHING THE UNIVERSAL JOINT TO STEERING GEAR .
• Refer to IF INSTALLED: SECURING THE LINE FOR THE VERTICAL ACCELERATION SENSOR ON THE RIGHT AND LEFT .
• Refer to ATTACHING THE CABLE OF THE WHEEL RPM SENSOR ON THE LEFT AND RIGHT .
• Refer to CLIP THE BRAKE HOSES ON THE FRONT RIGHT AND LEFT .
• Refer to IF INSTALLED: CONNECT THE CONNECTOR OF THE ACTIVE STABILIZER
• Refer to IF INSTALLED: INSTALL THE SILENCER OF THE STATIONARY HEATING (ADDITIONAL WORK FRU NO.: 31 11 905) .
• Refer to INSTALL THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT
• Refer to INSTALL THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to INSTALL LEFT AND RIGHT BRAKE VENTILATION DUCT .
• Refer to SECURE THE WIRING HARNESS FOR THE EPS ON THE FRONT AXLE SUPPORT .
• Refer to INSTALL THE REINFORCEMENT STRUT ON THE RIGHT ENGINE MOUNT .
• Refer to INSTALL THE COVER OF THE STEERING ASSEMBLY ON THE LEFT AND RIGHT .
• Refer to INSTALL THE FRONT LEFT AND RIGHT WHEELS .
• Refer to LOWERING THE ENGINE AND DETACHING THE ENGINE BRIDGE .
• Refer to FASTENING THE ENGINE SUPPORT BRACKETS ON THE ENGINE MOUNTS ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE MOUNT OF THE HOOD SEAL .
• Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
• Refer to REMOVING SPECIAL TOOL FROM THE CYLINDER HEAD .
• Refer to INSTALL RESONATOR .
• Refer to CONNECTING NEGATIVE BATTERY CABLE .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
• Refer to INSTALL THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
• Refer to INSTALL ACOUSTIC COVER .
• Refer to INSTALL THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
• Refer to Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
• Refer to INSTALL REAR UNDERBODY PROTECTION .
• Refer to TAKE HOOD OUT OF THE SERVICE POSITION .

• Install acoustic cover (1)  to the top front.

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure all expanding rivets (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connectors (1)  and lock.
• Make sure the connector (1)  engages audibly.
• Insert and install the positive battery cable (3).
• Secure positive battery cable (3) at the clamp (4).
• Tighten the nut (2) hand-tight.

Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the positive battery cable (1) correctly  to anti-twist lock (2)  .
• Tighten nut (3)  .

Courtesy of BMW OF NORTH AMERICA, INC.