Install swivel bearing

• Position swivel bearing (1).
• Replace screw (6) and the nut (5).

  Parts:  Bolt, nut

• Insert screw (6).
• Tighten the nut (5).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Upper wishbone to swivel bearing
  M10 Replace screw and nut.	Tightening torque	56 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the tie rod, lower wishbone and tension strut at the swivel bearing (1).
• Replace nuts (2), (3) and (4).

  Parts:  Nuts

• Tighten the nut (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Wheel guide joint to swivel bearing
  M30 Replace nut.	tightening torque	380 Nm

• Tighten the nut (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Tension strut to swivel bearing
  M16 Replace nut.	Joining torque	100 Nm
  	Angle of rotation	90°

• Tighten nut (4).

Follow-up work 

• Refer to SECURING THE SPRING STRUT HOLDER ON THE WISHBONE .
• Refer to SECURING THE HOLDER ON THE SWIVEL BEARING .
• Refer to INSTALLING BRAKE GUARD PLATE, FRONT .
• Refer to INSTALLING FRONT BRAKE DISC .
• Refer to FASTENING FRONT BRAKE CALIPER .
• Refer to INSTALLING THE FRONT WHEEL SPEED SENSOR .
• Refer to INSTALLING THE FRONT VERTICAL ACCELERATION SENSOR .
• Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
• Refer to MOUNTING THE WHEEL .
• Refer to PERFORMING CHASSIS ALIGNMENT CHECK .