Installing coolant feed line for exhaust turbocharger
- Replace O-rings (1) on the coolant feed line with the special tool 0 496 714 (00 9 030).
Parts: O-rings
- Guide in coolant feed line (2) on the crankcase and install.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line to crankcase | ||
|---|---|---|
| M6x 12 | Tightening torque | 8 Nm |
- Guide in coolant feed line (2) on the exhaust turbocharger and install.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line/coolant return line to exhaust turbocharger | ||
|---|---|---|
| M6x12 | Tightening torque | 8 Nm |
Follow-up work
- Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING CATALYTIC CONVERTER .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .