Removing the catalytic converter for cylinders 5 to 8 (Without Gasoline Particulate Filter)
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... RAISE THE VEHICLE USING A VEHICLE LIFT.
CAUTION:
Component with heavy weight.
Injury hazard!
Injury hazard!
- Note component's center of gravity.
- Support component using a jack.
- Secure component against falling off the jack.
Preliminary work
- Refer to REMOVE THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING CENTER REAR UNDERSHIELD .
- Refer to REMOVE EXHAUST SYSTEM .
- Refer to REMOVING THE RETAINING BRIDGE .
- Refer to PARTIALLY REMOVING THE LEFT LAMBDA OXYGEN SENSOR .
- Refer to PARTIALLY REMOVING THE LAMBDA OXYGEN SENSOR .
- Refer to REMOVING THE LEFT OXYGEN SENSOR MONITOR .
- Refer to REMOVING THE RIGHT OXYGEN SENSOR MONITOR .
- Refer to REMOVE UPPER HEAT SHIELD .
- Refer to REMOVING THE LEFT HEAT SHIELD .
- Refer to REMOVE RIGHT HEAT SHIELD .
- Refer to REMOVE THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVE THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT
- Refer to REMOVE LEFT AND RIGHT WIPER ARM .
- Refer to REMOVE THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE COWL UPPER PART IN THE CENTER .
- Refer to LIFTING THE HEAT SHIELD .
NOTE:
TECHNICAL INFORMATION
In order to be able to remove the catalytic converter for cylinders 5 to 8, the catalytic converter for cylinders 1 to 4 also needs to be removed.
In order to be able to remove the catalytic converter for cylinders 5 to 8, the catalytic converter for cylinders 1 to 4 also needs to be removed.
Version without gasoline particulate filter (SSA1DC)
WARNING:
Hot exhaust system.
Risk of burning!
Risk of burning!
- Any work must exclusively be carried out with an exhaust system that has cooled down.
- Release the nuts (1) at the bottom on the catalytic converter for cylinders 1 to 4.
- Loosen catalytic converter from holder.
- Release the nuts (1) at the bottom on the catalytic converter for cylinders 5 to 8.
- Loosen catalytic converter from holder.
- Loosen circlip (1) and remove.
- Loosen circlip (2) and remove.
- Loosen screws (1).
- Loosen screws (2).
- Loosen screw (3).
- Remove holder (4).
- Loosen screws (1).
- Loosen screws (2).
- Loosen screw (3).
- Remove holder (4).
- Remove the catalytic converter (1) for the cylinders 1 to 4 in arrow direction.
- Unscrew and remove the catalytic converter (1) for the cylinders 1 to 4 in arrow direction.
- Remove the catalytic converter (1) for the cylinders 5 to 8 in arrow direction.
- Unscrew and remove the catalytic converter (1) for the cylinders 5 to 8 in arrow direction.
