Install oil feed line
- Replace the O-rings (1).
Parts: O-rings
- Position oil feed line (2) on exhaust turbocharger.
- Tighten down screw (1).TIGHTENING TORQUES SPECIFICATION
Oil feed line to exhaust turbocharger M6 x 12 tightening torque 8 Nm
Follow-up work
- Refer to INSTALLING EXHAUST TURBOCHARGER .
- Refer to INSTALLING THE COOLANT FEED LINE (COOLANT RETURN LINE IS REMOVED) .
- Refer to INSTALLING HEAT SHIELD FOR CYLINDER HEAD COVER .
- Refer to INSTALLING THE FRONT SECTION OF THE COOLANT RETURN LINE .
- Refer to INSTALLING THE OIL RETURNING LINE FOR THE EXHAUST TURBOCHARGER .
- Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to INSTALLING CATALYTIC CONVERTER .
- Refer to REPLACING THE OXYGEN MONITOR SENSOR .
- Refer to REPLACING THE LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING BOTTOM CLEAN AIR PIPE .
- Refer to INSTALLING THE RESONATOR WITH THE TOP CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to PREPARING THE EXHAUST SYSTEM .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING THE THRUST FIELD .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .