Installing left intake system
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Attach intake system (2) on cylinder head. Pay attention to the fastening on the cylinder head while doing this.
- Hand-tighten both bolts M8 (arrows).
- (1) Hand-tighten the bolts M6.
- Tighten the bolts M8 with internal Torx T40 (arrows).
TIGHTENING TORQUES SPECIFICATION
| Intake plenum to cylinder head M8 T40 | ||
|---|---|---|
| M8x33 | Tightening torque | 20 Nm |
- Tighten the bolts M6 with internal Torx T30 (1).
TIGHTENING TORQUES SPECIFICATION
| Intake plenum to cylinder head M6 T30 | ||
|---|---|---|
| M6x30 | Tightening torque | 10 Nm |
Follow-up work
- Refer to INSTALLING AIR CONDITIONING COMPRESSOR .
- Refer to INSTALLING FRONT AXLE COMPLETELY .
- Refer to TIGHTENING THE BOLTS ON THE FRONT AXLE SUPPORT .
- Refer to SECURING CABLES ON VERTICAL ACCELERATION SENSOR ON RIGHT AND LEFT .
- Refer to IF INSTALLED: INSTALL THE SILENCER OF THE STATIONARY HEATING (ADDITIONAL WORK FRU NO.: 31 11 905) .
- Refer to INSTALLING THE UNIVERSAL JOINT .
- Refer to INSTALLING THE BRAKE CALIPER AT THE FRONT LEFT AND RIGHT .
- Refer to SECURING THE SPRING STRUT TO THE BOTTOM WISHBONE .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to ATTACHING THE CABLE OF THE WHEEL RPM SENSOR ON THE LEFT AND RIGHT .
- Refer to ATTACHING COOLANT HOSES TO FRONT SUBFRAME .
- Refer to SECURING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT TO THE ANTI-ROLL BAR .
- Refer to SECURING THE TOP WISHBONE ON THE SWIVEL BEARING .
- Refer to INSTALLING THE REINFORCEMENT STRUT ON THE ENGINE MOUNT ON THE LEFT AND RIGHT .
- Refer to IF INSTALLED: CONNECT THE CONNECTOR OF THE ACTIVE STABILIZER .
- Refer to INSTALLING THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
- Refer to INSTALLING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to INSTALLING THE RIGHT THROTTLE BODY .
- Refer to INSTALLING THE RIGHT-HAND CHARGE AIR COOLER .
- Refer to CONNECTING THE RIGHT CHARGE AIR LINE TO THE EXHAUST TURBOCHARGER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE RIGHT UNFILTERED-AIR DUCT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING BOTH FRONT-END STRUTS .
- Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to FOR THE VALVETRONIC: LEARN THE STOPS WITH THE DIAGNOSTIC SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .