Remove all special tools

NOTE: RISK OF DAMAGE Prohibited reuse of used parts that have been removed to flush the refrigerant circuit.
Contamination of the refrigerant circuit, damage to the refrigerant circuit. Replace the following parts:

Air conditioning compressor
Expansion valve

NOTE: TECHNICAL INFORMATION
If the refrigerant circuit has been flushed, it is not necessary to adjust the amount of refrigerant oil when a new air conditioning compressor is installed.

NOTE: TECHNICAL INFORMATION
Once the flushing is complete, remove all the special tools just before the installation of the new parts .

Follow-up work

Install EXPANSION VALVE .
Install air conditioning COMPRESSOR .
Install the STEERING GEAR .
Install the UNIVERSAL JOINT .
Attach both tie rod ends to the SWIVEL BEARING .
If installed: fasten the ACTIVE STABILIZER (additional work for ARS).
Install the ANTI-ROLL BAR .
Install the THRUST FIELD .
Install the UNDERBODY PROTECTION of the steering gear or the front thrust field.
Install the front UNDERBODY PROTECTION .
Install the front left and right WHEELS .
Install fan COWL .
Install the rear top CROSS CONNECTION .
Install front CROSS CONNECTION .
Install left and right front-end STRUT .
Install the top right engine compartment COVER .
Install the top engine compartment COVER .
Install intake filter HOUSING .
Install acoustic COVER .
Evacuate and charge CONDITIONING .
Run in the new air conditioning COMPRESSOR .
Perform CHASSIS ALIGNMENT check.
Check the AIRBAG function.