Installing high-voltage connection for the electrical machine (vehicle underbody)

• Position the high-voltage cable (1) on the holder (3) in the direction of the arrow.
• Insert and install the holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position holder (2).
• Tighten down screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in and install the high-voltage connector (2).
• Tighten the screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the high-voltage connectors (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Install right sealing FRAME
• Tighten engine WIRING HARNESS .
• Install the INTAKE PLENUM .
• Install control unit BRACKET .
• Install the DME CONTROL UNIT .
• Install the tank VENT VALVE .
• Install rear ACOUSTIC COVER .
• Install the rear front HOOD SEAL .
• Install the front acoustic engine COVER .
• Install charge AIR LINE .
• Connect the coolant line of low-temperature COOLANT CIRCUIT
• Fill the low-temperature COOLING SYSTEM with the vacuum filling equipment
• Install clean AIR PIPE .
• Install RESONATOR .
• Install acoustic COVER .
• Vent the low-temperature COOLING SYSTEM .
• Install the UNDERBODY PROTECTION of the steering gear or the front thrust field
• Install the front UNDERBODY PROTECTION or front thrust field.