Install brake caliper in the rear

• Attach brake hose to the holder (1).
• Attach and tighten brake hose (2) on brake caliper.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake hose to brake caliper, rear
  	Tightening torque	24 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the brake hose is not is not twisted or resting on components attached to the body.
• Attach and tighten union screw (1).

  Hold on to square shaft, if necessary (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Remove the brake pedal TENSIONER .
• Grease BRAKE PADS , brake anchor plate and brake caliper with brake pad paste.
• Install rear BRAKE PADS .
• Install the rear brake pad WEAR SENSOR .
• Install rear left or right WHEEL .
• Connect the brake fluid BLEEDER UNIT .
• FLUSH AND VENT  the rear axle brake circuit.
• Disconnect the brake fluid BLEEDER UNIT .
• START-UP OR BEDD IN new brake pads and blades (rear brake).