Cylinder head cover screw connection cylinder 5 to 8 difficult to access

• The cylinder head cover screws found in the rear area of the cylinder head cover can be secured with a wobble joint (1) (swivel).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to FASTEN THE SCREW TO THE HEAT SHIELD AT THE FRONT LEFT .
• Refer to FASTEN THE SCREW ON THE HEAT SHIELD ON THE FRONT RIGHT .
• Refer to INSTALL THE FRONT HEAT PROTECTION .
• Refer to REPLACE THE SEAL FOR THE EXHAUST GAS TURBOCHARGER .
• Refer to REPLACING THE OIL RETURN LINE .
• Refer to INSTALL EXHAUST TURBOCHARGER FOR CYLINDER 1 TO 4 .
• Refer to FASTEN THE BANJO BOLT FOR THE COOLANT FEED LINE TO THE EXHAUST TURBOCHARGER OF THE CYLINDERS 1 TO 4 .
• Refer to REPLACING THE OIL RETURN LINE .
• Refer to INSERT THE EXHAUST TURBOCHARGER FOR THE CYLINDERS 5 TO 8 .
• Refer to SECURING OIL FEED LINE ON EXHAUST TURBOCHARGER OF CYLINDERS 5 TO 8 .
• Refer to SECURING BANJO BOLT OF COOLANT RETURN LINE ON EXHAUST TURBOCHARGER FOR CYLINDERS 5 TO 8
• Refer to SECURE THE COOLANT FEED LINE ON THE EXHAUST TURBOCHARGER OF CYLINDERS 5 TO 8 .
• Refer to ATTACH THE OIL SUPPLY LINE ON THE EXHAUST TURBOCHARGER OF CYLINDERS 1 TO 4 .
• Tighten down screw (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  Oil feed line to exhaust turbocharger
  M6x16	Tightening torque	10 Nm

• Refer to FASTEN THE BANJO BOLT FOR THE COOLANT RETURN LINE ON THE EXHAUST TURBOCHARGER OF THE CYLINDERS 1 TO 4
• Refer to INSTALLING BANJO BOLT FOR COOLANT RETURN LINE AT EXHAUST TURBOCHARGER OF CYLINDERS 5 TO 8
• Refer to FASTEN THE OIL RETURN LINE ON THE OIL RETURN LID OF CYLINDERS 1 TO 4 .
• Refer to SECURE THE OIL RETURN LINE AT THE OIL RETURN COVER OF THE CYLINDERS 5 TO 8 .
• Refer to INSTALLING THE HEAT SHIELD AT CYLINDERS 5 TO 8 .
• Refer to HEAT PROTECTION OF THE LEFT-HAND CATALYTIC CONVERTER PIPE .
• Refer to HEAT PROTECTION OF THE RIGHT-HAND CATALYTIC CONVERTER PIPE .
• Refer to INSTALL UPPER HEAT SHIELD .
• Refer to INSTALL THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to IF INSTALLED: INSTALL THE TORSION STRUT ON THE RIGHT, AND ON THE LEFT WHERE REQUIRED .
• Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
• Refer to INSTALL THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALL LEFT CLEAN AIR PIPE .
• Refer to INSTALL RIGHT CLEAN AIR PIPE .
• Refer to INSTALL ENGINE VENTILATION LINE
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING FAN COWL .
• Refer to FILL THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to INSTALL ACOUSTIC COVER .